How to Make Arduino Based Digital Tachometer Simple DIY Tutorial

1) IR Sensor module :- http://amzn.to/2mOUVyw

2) LCD Screen :- http://amzn.to/2lxF1bp

3) Arduino Nano :- http://amzn.to/2lxF1bp

4) Zero PCB :- http://amzn.to/2lxF1bp

5) Header pins :- http://amzn.to/2lxF1bp

6) 9V Batter

Kindly go through the attached circuit diagram.

https://easyeda.com/sharmaz747/Arduino_techometer-...

IR Sensor Arduino

VCC----------------5V

GND----------------GND

OUT-----------------2(digital pin no. 2)

16X2 LCD Arduino

VSS------------------ GND

VCC----------------- +5V

VEE------------------ POT

RS-------------------- 12

R/W----------------- GND

E--------------------- 11

DB0----------------

DB1----------------

DB2----------------

DB3----------------

DB4------------------ 6

DB5------------------ 5

DB6------------------ 4

DB7---------------- 3

LED+--------------- +5V

LED----------------- GND

Visit https://easyeda.com/

to design & buy your custom make PCB

3 More Images

Bring a Zero PCB, Mount female header pin on PCB

Place arduino and LCD Screen on PCB

Make solder connection where it is required,

refer electrical drawing for better understanding.

place IR Senor module on PCB in way that its sensor face toward the

wheel of motor to whom RPM have to measure.

Connect the Arduino with PC to upload code.

Then connect the 9V battery to power up arduino & LCD 16 X 2 screen

you can adjust the brightness of screen by rotating that Knob connected at VEE of LCD Screen

Now you are ready to take RPM reading.

Manually rotate the Wheel of motor you can see RPM Reading are appear on screen

feel free to comment below

Thank for your attention hope you like this project

Click here to download Arduino code

upload the code to Arduino

Be sure you have selected right Board & port to successfully upload the code

Attachments

• tachometer-using-arduino.ino
  Download