Smartphone&iPhone Camera Grip

1. Cheap Bluetooth Remote Shutter
2. Small Wire
3. 2x M3 10mm Screws
4. Cheap Phone Case
5. Velcro Tape
6. DS-101 Micro Push Button Switch 8 mm
7. SS-12D00G3 Switch
8. Heat shrink tubing
9. 3D Printed Parts

Tools such as hot glue, epoxy glue, wire stripper, soldering iron, etc.

3D files Here!!!

Attachments

• Smart phone shutter lid.stl
  DownloadView in 3D
• Smart phone shutter.stl
  DownloadView in 3D

Test both buttons to figure out which one is compatible with your phone.

Both button works for my phone(Huawei P9).

3 More Images

1. Separate your Bluetooth remote into two pieces. (front cover and back cover)
2. Remove battery from the back cover. (Don't throw your back cover away!!!)
3. Cut holder part out and sand cutting points on cover part.

See more details in pictures.

5 More Images

1. Prepare 4x wires 10 cm long.
2. Soldering them to the board. (more details in the picture)
3. Coat with epoxy glue on PCB to prevent wires from moving. (Make sure that you set the switch to off position.)
4. Put PCB back to the back cover and glue it.

Put battery back in back cover and put circuit part in 3D printed cover take wires out through the holes. (more details in pictures)

Close the lid and screw it.

3 More Images

Solder buttons to wires and put and glue them in the holes.

2 More Images

1. Cut Velcro tape into 4 pieces of 6cm long. (2 hooks 2 loops)
2. Glue hooks to the back side of the grip and loops at the bottom end of the phone case.

See more details in pictures.

2 More Images

1. Attach grip part to smart phone case.
2. Turn on Bluetooth on your smartphone.
3. Turn it on!!!
4. Enjoy and take a photo.

• Thank you to my sister who helped me writing these instructions in English.
• Thank you for visiting.

If you like this tiny battery dispenser, please vote me and followmy Youtube channel.

P.S. This project video is coming soon.

; )