Trybotics Logo

Operating Servo Motor Through Arduino On Online Simulator

DESCRIPTION

Tinkercad is an online simulator platform available for various 3D circuit designing and printing. In this we will run a servo motor through arduino on tinkercad which is a online simulator.

  • Step 1- open tinkercad.com and register on it to start designing circuits online.
  • Step 2- Open the Designing window and select an arduni board and a servo motor and connect it as shown in circuit diagram.
  • Step 3- open the code window, and do the selected settings like the angle at which the motor should be rotated.
  • Step4- click in simulate to run the circuit

Arduino codes is also available on tinkercad you can download it from the website and design the above circuit physically.

Description:

A000066 iso both
Arduino UNO & Genuino UNO
×1
Servo Motor
×1

Description:

Jumper wires

Description:

Tinkercad is an online simulator platform available for various 3D circuit designing and printing. In this we will run a servo motor through arduino on tinkercad which is a online simulator.

  • Step 1- open tinkercad.com and register on it to start designing circuits online.
  • Step 2- Open the Designing window and select an arduni board and a servo motor and connect it as shown in circuit diagram.
  • Step 3- open the code window, and do the selected settings like the angle at which the motor should be rotated.
  • Step4- click in simulate to run the circuit

Arduino codes is also available on tinkercad you can download it from the website and design the above circuit physically.

Description:

servo_code.inoC/C++
#include <Servo.h>

int pos = 0;

Servo servo_9;

void setup()
{
  servo_9.attach(9);

}

void loop()
{
  // sweep the servo from 0 to 180 degrees in steps
  // of 1 degrees
  for (pos = 0; pos <= 180; pos += 1) {
    // tell servo to go to position in variable 'pos'
    servo_9.write(pos);
    // wait 15 ms for servo to reach the position
    delay(15); // Wait for 15 millisecond(s)
  }
  for (pos = 180; pos >= 0; pos -= 1) {
    // tell servo to go to position in variable 'pos'
    servo_9.write(pos);
    // wait 15 ms for servo to reach the position
    delay(15); // Wait for 15 millisecond(s)
  }
}

Description:

Circuit Diagram Through Eagle
Download
fabulous_amur-hillar_(1)_p0WQSoWIrP.brd

Description:

ci_qxT9nA9Yjq.JPG
Download
Ci qxt9na9yjq

YOU MIGHT ALSO LIKE